150+ POINT INSPECTION
WE GO OVER EVERY INCH
SO YOU CAN COVER EVERY MILE.
You might not worry much about the condition of your hose clamps or the vacuum system or the brake pads. You'll never have to, either, with one of our GM Certified Pre-Owned Vehicles. Before they reach the sales floor, each one of our vehicles is meticulously looked over by a licensed mechanic. That means by the time you look at them, every single vehicle has passed our painstaking 150+ point inspection.
The 150+ point inspection includes:
ENGINE
Check the vehicle mileage against service records for accuracy.
ENGINE COMPARTMENT
Hood release, hinges, prop rod or gas struts provide proper operation.
Check finish (rust, corrosion).
ENGINE CONDITION & NOISE
Verify original equipment and displacement
Valve cover/cylinder head/exhaust manifold gaskets soundness
Condition of engine belts, automatic tensioner, hoses, wires and no squeaking belts
Condition of hose clamps, retainer clips, and wire casings
Look for areas of concentrated dirt or grime
Check for fluid leaks or valvetrain noise
Vacuum system condition
Fuel delivery system
ENGINE OIL LEVEL/CONDITION
Check engine oil level, verify oil clarity and viscosity.
ENGINE COOLANT LEVEL/CONDITION
Check radiator for leaks and damage/fan shroud is securely in place
Verify that blades of cooling fans are not broken or bent
Check coolant level, freeze protection rating
AIR FILTER INSPECTION
Inspect air filter/filter housing for debris (leaves, bugs).
BATTERY LOAD TEST
Inspect battery for cracks. Clean and inspect battery top, posts & cables
Measure battery voltage/conduct load test
IGNITION SYSTEM
Inspect system for loose, cracked or burned wires.
Check wire for short circuits and arcing
POWER STEERING FLUID LEVEL
Inspect power steering fluid level
BRAKE FLUID LEVEL
Locate and inspect master cylinder reservoir, check brake fluid level
AUTOMATIC TRANSMISSION FLUID LEVEL & CONDITION
Check all ranges from "Park" to "1st" for proper engagement.
FUEL SYSTEM
Inspect fuel injection system for proper operation
Check fuel system for leaks or loose wires and lines
Inspect evaporative emissions for proper operation
MANUAL TRANSMISSION FLUID LEVEL
Measure fluid level, clarity and viscosity (if equipped).
MANUAL TRANSMISSION HYDRAULIC CLUTCH FLUID LEVEL
Check clutch fluid reservoir for proper level.
WASHER FLUID LEVEL
Inspect/fill washer fluid reservoir (front)/(rear, if equipped).
STARTER PERFORMANCE (AUTOMATIC TRANSMISSION)
Check that starter only operates in "Park" or "Neutral".
STARTER PERFORMANCE (MANUAL TRANSMISSION)
Starts only when clutch pedal pressed all the way down (GM Vehicles).
INSTRUMENTATION AND INTERIOR COMPONENTS INSPECTION
OnStar® system - verify connection to OnStar® with blue button push
SRS system warning light/self test
ABS system warning light/self test
INSTRUMENT PANEL
Instrument panel/gauge lights and operation
Electronic instrument cluster, Head-up Display operational (if equipped)
CLIMATE CONTROL
HVAC/Front and Rear Electronic Climate Control (if equipped)
All climate control directional functions/vents working properly
Confirm Cabin Air Filter is clean
AUDIO/VIDEO SYSTEM
Audio controls, speakers, steering wheel controls (if equipped)
Power antenna (if equipped)
DVD player operational (if equipped)
Navigation system operational (if equipped)
Infotainment Systems verify operation of system with Multimedia Interfact Tool (MIT Tool) , display screen, USB, Bluetooth, AUX jack,
etc., (if equipped)
WINDSHIELD WIPER/WASHER OPERATION
Front wiper/washer controls are operational
Front wiper blades
Rear wiper/washer controls are operational (if equipped)
Rear wiper blade (if equipped)
ELECTRIC REAR WINDOW DEFROSTER OPERATION
Defroster switch/heating grid operation
HORN OPERATION
Horn operation/sound quality
LIGHTER/POWERPOINT OUTLETS
Cigarette lighter, USB, AUX, powerpoints operational
TILT STEERING WHEEL (IF EQUIPPED)
Steering wheel locks in each tilt position
Confirm operation of heated steering wheel (if equipped)
INSIDE REARVIEW MIRROR
Rearview mirror adj., range of movement, Auto dim (if equipped)
Map/Reading lights (if equipped)
WINDOWS
Power windows and controls are operational (if equipped)
Sliding rear window/vent windows (if equipped)
OUTSIDE MIRROR CONTROLS
Check mirrors for full movement in all directions
Inspect mirrors for clarity, scratches or cracks
Heated Mirrors/Personal Memory systems function (if equipped)
POWER SUNROOF OPERATION (IF EQUIPPED)
Sunroof opens, tilts and closes properly
Check sunroof track for any obstructions or damage
Check sunroof seals for any cracks or damage
REMOVABLE ROOF PANELS (IF EQUIPPED)
Roof panel latches
Check roof panel weather stripping for cracks or damage
CONVERTIBLE TOP OPERATION (IF EQUIPPED)
Headliner condition (if equipped)
Check roof structure for bent rods or damage
Top opens and closes fully
Rear window, glass or plastic condition
Convertible top seals and clamps
INTERIOR TRIM INSPECTION
SEAT FABRIC AND TRIM CONDITION
Inspect vehicle seats for wear, stains or tears
Passenger compartment trim panels fit and finish
Headliner fit and condition
SEAT ADJUSTMENT
Driver and Passenger seat tracks are operational
Adjustable head restraints (if equipped)
Folding rear seatback/Valet Lockout feature (if equipped)
Driver/passenger/rear seat controls are operational
SAFETY BELT CONDITION/INTEGRAL CHILD SEAT OPERATION
All seat belts are operational
Inspect safety belt webbing and buckles at all seating positions
Height adjustable shoulder belts work correctly (if equipped)
Check that integral child seat is operating properly (if equipped)
Inspect all child seat hardware and latches
SUN VISOR OPERATION AND CONDITION
Su
n visors are operational
n visors are operational
INTERIOR/COURTESY LIGHT OPERATION
Check that all interior lights/switches are operational
REMOTE DECKLID/LIFTGATE RELEASE OPERATION
Check operation of decklid/liftgate during remote release
Inspect weather seal for damage
Decklid pull down feature (if equipped)
REMOTE FUEL FILLER DOOR RELEASE OPERATION (IF EQUIPPED)
Inspect operation of the remote fuel filler door release feature
Interior fuel door switch, release mechanism working properly
Confirm capless fuel filler is intact and working correctly
ASHTRAY
Inspect ashtray for broken, bent, or melted components
GLOVE BOX OPERATION
Inspect latch, lock, and hinges for proper operation
DOOR TRIM AND LOCK OPERATION
- Check that all doors open and close smoothly
- Inspect operation manual or power door locks, rear door security lock
- Check that doors cannot be opened in the “Locked” position
- Check hand held remote transmitter operational (if equipped)
- Check all interior/exterior door handles for damage
- Check and confirm child door lock operation
- Inspect fit and finish of each door trim panel, armrest, assist strap
CARPET AND FLOOR MAT CONDITION
- Inspect carpet and floor mats for burns, dirt, excessive wear
CARGO AREA
- Inspect cargo area trim panels for fit and finish
- Cargo area, door lock switch operation, powerpoint power (if equipped)
SPARE TIRE CONDITION/JACK & WRENCH LOCATION
- Inspect spare tire and wheel condition
- Inspect that all tools needed for spare tire change are intact, or if
- equipped with spare tire delete, the fill kit is available
PRE-TEST DRIVE INSPECTION
HEAD LAMP/FOG LAMP OPERATIONS
- Headlamp switch, High/Low beam is functional
- Headlamps are aimed properly
- Twilight/headlamp delay feature OK (if equipped)
- Fog lamps are aimed and functional (if equipped)
PARKING/BRAKE/BACK UP/TURN & SIDE MARKER LAMPS
- Front and rear parking lamps
- Brake and backup lamps
- Left/Right turn signal lamps
HAZARD WARNING LIGHTS
- Hazard warning lights work with vehicle running/not running
WHEEL AND TIRE CONDITION
- (INSPECT PRE TEST DRIVE AND IN SERVICE BAY)
- Tires meet 4/32” minimum requirement
- Tire build dates (DOTs) within 6 years
- Wheel covers/wheel centre hubs OK (if equipped)
- Tire side walls, valve stems, and wear pattern
- Tire size/correct air pressure/lug nuts secured
- Inspect wheel rims for damage
SHOCK ABSORBER TEST
- Front shock absorbers/strut assembly
- Rear shock absorbers/strut assembly
THE TEST DRIVE
BRAKE SHIFT/TRANSMISSION INTERLOCK
- (AUTOMATIC TRANSMISSION)
- Gear selector cannot be moved out of Park unless brake is applied
TRANSMISSION OPERATION (AUTOMATIC)
- Transmission gear engagement/shift points are smooth
TRANSMISSION OPERATION (MANUAL)
- Clutch pedal/gear shift engagement
- Inspect transmission for noise
ENGINE PERFORMANCE
- Engine driveability/performance
BRAKE OPERATION
- Power assisted braking system is functional
- Rear parking assistance monitor operational (if equipped)
- Anti-lock brake system warning/self-test light is functional
- Anti-lock brake system functional (if equipped)
- Vehicle tracks straight under hard braking conditions
SUSPENSION/DRIVETRAIN/NOISE
VIBRATION HARSHNESS
- Inspect for abnormal vehicle noise, windnoise, vibrations or harshness
CORNERING ABILITY
- Vehicle cornering dynamics
- Inspect for vehicle abnormal body roll
CRUISE CONTROL (IF EQUIPPED)
- Cruise control holds a set speed/adjustments work properly
ACTIVE SAFETY Test/inspect if equipped
- Heads up display - alerts are functional
- Haptic seats
- Audible warnings
- Collision Alert
- Cross Traffic Alert
- Side Blind Zone Alert
- Adaptive Cruise
- Lane Centering
- Super Cruise
- Front and Rear Park Assist
- Front and Rear Camera
- 180 Bird's eye view Camera
SERVICE BAY INSPECTION
TRANSMISSION CASE INSPECTION
- Transmission case/pan structurally sound
MANUAL TRANSMISSION FLUID LEVEL AND CONDITION
- Fluid level, clarity and condition
TRANSFER CASE (4-WHEEL DRIVE AND AWD MODELS)
- Fluid level, clarity and condition
- Transfer case/skid plate structural condition
BRAKE SYSTEM CONDITION
- Brake rotor/drum surfaces
- Brake pads/shoes have 40% or more remaining pad life
- Brake shoes have 40% or more remaining life
- Parking brake operation
ENGINE MOUNTS/FRONT SUSPENSION LINKS & BUSHINGS
- Inspect all engine mounts, grommets and bushings
- Front suspension links/sway bar/mounts
STRUTS AND SHOCK ABSORBER CONDITION
- Shock absorbers/struts free of leaks and damage
STEERING SYSTEM CONDITION
- Inspect structural condition of all steering system elements
CV JOINT DUST BOOT CONDITION
- CV dust cover boot void of rips/damage
DRIVE AXLE, AXLE FLUID LEVELS
- Inspect differential case for fluid leaks
- Front/Drive axle fluid level
FUEL TANK SYSTEM CONDITION
- Fuel tank and delivery lines are sound, no fuel odour
VEHICLE/STRUCTURAL DAMAGE
- Inspect for signs of collision damage
EXHAUST SYSTEM
- Exhaust system hung/routed properly, meets structural integrity, exhaust tone
ENGINE OIL AND FILTER CHANGE, CHASSIS LUBE
- Lubricate all chassis points, perform engine oil and filter change
ELECTRIC VEHICLES
- Confirm that the low voltage charger is operational and will charge the vehicle
- Confirm that the vehicle can be charged with a level 2 charger
- Confirm (if equipped) that the vehicle can be charged with the High Voltage DC charger
EXTERIOR WEAR AND TEAR INSPECTION
WINDOW GLASS
- Inspect all glass surfaces for chips and cracks
HOOD CONDITION
- Inspect hood for proper alignment with fenders, grille, and fascia
- Inspect hood’s finish for dents and scratches
GRILLE, FRONT BUMPER, AND FASCIA CONDITION
- Check that bumper guards and rubstrips are securely fastened
- A Check grille, front bumper, or fascia alignment/condition
- Vehicle is free from road tar and tree sap
DRIVER SIDE FENDER, DOOR(S), QUARTER PANEL CONDITION
- Inspect for panel alignment, finish quality, previous body work
- Weather seals, placement/condition
- Bodyside mirrors, mouldings and badging properly secured
DECKLID, LIFTGATE, TAILGATE OR REAR CARGO DOOR CONDITION
- Inspect the rear body panel surfaces for dings, dents and scratches
- Decklid, liftgate or rear panel doors
- Weather seals, placement/condition
- Pickup tailgate/bed/side rails (if equipped)
- Inspect bedliner
REAR BUMPER/FASCIA CONDITION
- Inspect all rear trim components for proper fit, or collision damage
- Check that all bumper guards and rubstrips are securely fastened
PASSENGER SIDE FENDER, DOOR(S) QUARTER PANEL CONDITION
- Inspect areas for panel alignment, finish quality, or previous body work
- Weather seals, placement/condition
- Bodyside mirrors, mouldings and badging properly secured
ROAD ANTENNA
- Inspect mast antenna, antenna secured
FINAL INSPECTIONS
- Engine compartment is clean/degreased
- Interior compartment has been cleaned
- Vehicle exterior has been washed
Vehicles are not eligible to be marketed as Certified Pre-Owned vehicles unless the dealer first performs all open safety, emissions and non-compliance recall repairs. GM has instructed its dealers to check for open recalls and to perform all needed repairs before listing any vehicle as a Certified Pre-Owned vehicle. Dealers are required to determine whether there is an open recall on a vehicle by entering the Vehicle Identification Number at the GM Canada Recall Centre website recalls.gm.ca.